source: trunk/conf/svnserve.conf @ 746

Last change on this file since 746 was 746, checked in by Rodolfo Rodrigues, 13 years ago
File size: 2.3 KB
Line 
1### This file controls the configuration of the svnserve daemon, if you
2### use it to allow access to this repository.  (If you only allow
3### access through http: and/or file: URLs, then this file is
4### irrelevant.)
5
6### Visit http://subversion.tigris.org/ for more information.
7
8[general]
9### These options control access to the repository for unauthenticated
10### and authenticated users.  Valid values are "write", "read",
11### and "none".  The sample settings below are the defaults.
12# anon-access = read
13# auth-access = write
14### The password-db option controls the location of the password
15### database file.  Unless you specify a path starting with a /,
16### the file's location is relative to the directory containing
17### this configuration file.
18### If SASL is enabled (see below), this file will NOT be used.
19### Uncomment the line below to use the default password file.
20# password-db = passwd
21### The authz-db option controls the location of the authorization
22### rules for path-based access control.  Unless you specify a path
23### starting with a /, the file's location is relative to the the
24### directory containing this file.  If you don't specify an
25### authz-db, no path-based access control is done.
26### Uncomment the line below to use the default authorization file.
27# authz-db = authz
28### This option specifies the authentication realm of the repository.
29### If two repositories have the same authentication realm, they should
30### have the same password database, and vice versa.  The default realm
31### is repository's uuid.
32# realm = My First Repository
33
34[sasl]
35### This option specifies whether you want to use the Cyrus SASL
36### library for authentication. Default is false.
37### This section will be ignored if svnserve is not built with Cyrus
38### SASL support; to check, run 'svnserve --version' and look for a line
39### reading 'Cyrus SASL authentication is available.'
40# use-sasl = true
41### These options specify the desired strength of the security layer
42### that you want SASL to provide. 0 means no encryption, 1 means
43### integrity-checking only, values larger than 1 are correlated
44### to the effective key length for encryption (e.g. 128 means 128-bit
45### encryption). The values below are the defaults.
46# min-encryption = 0
47# max-encryption = 256
Note: See TracBrowser for help on using the repository browser.